Beurer GL Instruções de Operação descarregar pdf (Página 24)

Beurer GL32 mg/dL

• Do not use the control solution if either of these dates has expired (

/ ).

• Allow the measuring device, test strips and control solution to reach room temperature

(+20°C to +25°C).

Performing a function test using the control solution

Hold the measuring device so that the display is facing you.

Insert a test strip into the slit on the measuring device, contacts first. Ensure

that the front side of the test strip is facing towards you (see "3.3 Test strip",

page 11).

The device switches on automatically and shows the start display, shortly

followed by the checking symbol “

“. As soon as the flashing blood droplet

symbol 6 is displayed, the device is ready to perform measurements.

Press the ON/OFF/Forwards button to switch to control mode. In control

mode, the measured value is not stored and hence does not distort your

measurement statistics.

"CTL" appears in the display.

Shake the control solution well before use. Unscrew the cap and squeeze out

a drop of solution. Wipe away the first drop and squeeze out an additional

drop.

To prevent the remaining control solution in the bottle from becoming con-

taminated through the tip of the bottle in contact with the test strip, do not

apply the drop directly to the test strip. Instead, apply the drop to a clean

surface, and then apply the drop from there to the blood collection slit on the

test strip. The solution is sucked into the slit. Wipe the tip of the bottle using a

clean, dry paper tissue.

Once the slit is filled with solution, the device begins the measurement. The

device counts down for 6 seconds, and the result of the measurement is then

shown in the display.

Check whether the result is within the specified results range for the control

solution. This results range is printed on the test strip container.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Sem comentários

Beurer GL Instruções de Operação Página 24